Draft
Draft(solid, angle_deg, neutral_plane_name="XY") tapers faces so a part
can be pulled out of a mould or a casting. The faces keep their size on the
neutral plane and lean inward by angle_deg going along the pull direction,
which is that plane’s normal: "XY" pulls along +Z, "YZ" along +X, "XZ"
along +Y.
By default every planar face parallel to the pull direction (all the side
walls) is drafted. Pass edge_finder=FaceFinder(rule=…) to draft only some
faces.
Draft composes like any other modifier. The tray on the right is
Shell(Draft(Extrusion), 1.5): draft first, then hollow.