Chaining Flanges
A flange can be bent off another flange, not only off the base. Point the
edge flange at the flange you want to continue from with
EdgeRef(flange=<operation>). The kernel finds that flange’s edge in 3D,
so you don’t have to compute where the wall ended up.
flange_edge | Edge |
|---|---|
FREE (default) | the edge opposite the bend, e.g. the top of a wall |
START_SIDE / END_SIDE | the two side edges of the flange |
Passing the operation itself as the edge (edge=wall_r) is shorthand for its
FREE edge.
A flange folds toward the bend side of the face it starts from. That makes
the default a lipped C-channel; use a negative bend_angle to fold to the
other side. The hat channel above uses bend_angle=-90 for its outward feet.
The flat pattern (right, orange) lays out every flange next to the flange it
was bent from: web, wall, foot, each separated by its bend allowance
(radius + k_factor * thickness) * angle.