Rip
Rip(solid, edge_finder, gap=0.5) cuts a gap-wide slot along each
selected straight edge of a thin-walled (shelled) solid. The slot sits in the
plane that bisects the two faces meeting at the edge, so the walls come apart
at that corner while the rest of the part stays intact.
Above, an open box with 2 mm walls is ripped along its four vertical corners:
each wall now only joins the base, like an unglued carton. Rip a shelled solid
before converting it to sheet metal
(SheetMetalFromSolid), or to
open a seam in any shelled part.
Select the edges with an EdgeFinder. A ContainsPointFinderRule per
corner, combined with EitherFinderRule, picks exactly the outer corner
edges.